Important Requirement

This Attackers script must be placed in Slot 1.

Failure to do so will cause incorrect behavior or features not working.

Initial Setup

• Set all control binds in the script to match your in-game controller binds

Menu Navigation (Updated)

• Open Menu: Menu + LT

• Navigate: D-Pad Left / Right to switch modes, Up / Down to adjust values

• Toggle Features: D-Pad Up / Down

• Edit Values: Press A / X when “EDIT” is shown

• Exit Menu: B button

• Toggle All Features: VIEW + LT

• Script Switching: Switch between Attackers / Defenders directly in the menu

Adjusting Recoil In-Game

1. Open Menu (Menu + LT)

2. Select Operators → Choose Operator

3. Select Primary / Secondary → Choose Weapon

4. Press A / X to enter adjustment mode

5. Use D-Pad Left / Right to switch between:

   • Vertical recoil (Up / Down adjusts)

   • Horizontal recoil (Up / Down adjusts)

Permanent Recoil Setup Instructions

To save recoil values permanently so they persist after reloading the script:

1. Locate the recoil arrays in the INIT section

2. Example (Ash – R4-C):

   • attackerPrimaryVerticalRecoil[3 * 3 + 0] = 40;

   • attackerPrimaryHorizontalRecoil[3 * 3 + 0] = -1;

    

3. Value Ranges:

   • Vertical: 0–100 (higher = stronger downward pull)

   • Horizontal: -100 to 100 (positive = right, negative = left)

Troubleshooting

• Menu Not Responding

  1. Close and reopen the menu (Menu + LT)

  2. Check controller connection

  3. Report the issue in Discord

   

• Anti-Recoil Not Working

  1. Ensure Mod Toggle is ON (VIEW + LT)

  2. Verify weapon assignments in the menu

   

• VM Speed Issues

  1. Try different presets

  2. For custom speed, use values between 1–20