Top Frag Attackers V3.1 – Rainbow Six Siege Cronus Zen Script

Important Requirement

This Attackers script must be placed in Slot 1.

Failure to do so will cause incorrect behavior or features not working.

Initial Setup

• Set all control binds in the script to match your in-game controller binds

Menu Navigation (Updated)

• Open Menu: Menu + LT

• Navigate: D-Pad Left / Right to switch modes, Up / Down to adjust values

• Toggle Features: D-Pad Up / Down

• Edit Values: Press A / X when “EDIT” is shown

• Exit Menu: B button

• Toggle All Features: VIEW + LT

• Script Switching: Switch between Attackers / Defenders directly in the menu

Adjusting Recoil In-Game

1. Open Menu (Menu + LT)

2. Select Operators → Choose Operator

3. Select Primary / Secondary → Choose Weapon

4. Press A / X to enter adjustment mode

5. Use D-Pad Left / Right to switch between:

   • Vertical recoil (Up / Down adjusts)

   • Horizontal recoil (Up / Down adjusts)

Permanent Recoil Setup Instructions

To save recoil values permanently so they persist after reloading the script:

1. Locate the recoil arrays in the INIT section

2. Example (Ash – R4-C):

   • attackerPrimaryVerticalRecoil[3 * 3 + 0] = 40;

   • attackerPrimaryHorizontalRecoil[3 * 3 + 0] = -1;

    

3. Value Ranges:

   • Vertical: 0–100 (higher = stronger downward pull)

   • Horizontal: -100 to 100 (positive = right, negative = left)

Troubleshooting

• Menu Not Responding

  1. Close and reopen the menu (Menu + LT)

  2. Check controller connection

  3. Report the issue in Discord

   

• Anti-Recoil Not Working

  1. Ensure Mod Toggle is ON (VIEW + LT)

  2. Verify weapon assignments in the menu

   

• VM Speed Issues

  1. Try different presets

  2. For custom speed, use values between 1–20