How to Use This Script

• Initial SetupSet the control bindings in the script to match your in-game controller settings.
• Menu NavigationOpen Menu: Menu Button + LT
• Navigate:
• D-Pad Left/Right: Switch modes
• D-Pad Up/Down: Adjust values
• Toggle Features: D-Pad Up/Down
• Edit Values: Press A/X when "EDIT" is shown
• Exit Menu: Press B
• Toggle All Features: VIEW + LT
• Adjusting Recoil In-GameEnter Menu (Menu + LT)
• Go to Operators → Choose side → Select operator
• Choose primary or secondary weapon
• Press A/X to enter adjustment mode
• Use D-Pad Left/Right to switch between:
• VERTICAL: Up/Down adjusts vertical recoil
• HORIZONTAL: Up/Down adjusts horizontal recoil
• DEADZONE: Up/Down adjusts stick sensitivity
• Weapon SwitchingIf your primary/secondary weapons get mixed up:
• Pause the game
• Press your bound weapon switch button
• This will reset the weapon assignment
• TroubleshootingIf the script stops responding:
• Toggle mod off/on (Menu + LT)
• Check your controller connection
• Restart the game
• Reopen the menu if unresponsive

Permanent Recoil Setup

• Recoil tuning requires 10–20 minutes per operator
• Fine-tuning leads to better long-term recoil control
• To save settings permanently, locate these arrays in the INIT section:
• AttackersattackerVerticalRecoil[]
• attackerHorizontalRecoil[]
• attackerVerticalRecoilSecondary[]
• attackerHorizontalRecoilSecondary[]
• DefendersdefenderVerticalRecoil[]
• defenderHorizontalRecoil[]
• defenderVerticalRecoilSecondary[]
• defenderHorizontalRecoilSecondary[]
• Example for Ash (index [2] in arrays):
• attackerVerticalRecoil[2] = 33;
• attackerHorizontalRecoil[2] = -1;
• attackerVerticalRecoilSecondary[2] = 19;
• attackerHorizontalRecoilSecondary[2] = 1;
• Value guidelines:
• Vertical: 0–100 (positive pulls down)
• Horizontal: -100 to 100
• Negative: compensates right sway
• Positive: compensates left sway

Finding Proper Recoil Values

• Go to the Shooting Range in-game
• Fire a full magazine at a wall
• Observe vertical and horizontal movement
• Start with the default values in the script
• Adjust recoil in small increments (5–10 points)
• Test fire after every adjustment
• Suggested Tuning Order:
• Set vertical until recoil is neutralized
• Adjust horizontal to eliminate sideways drift
• Only adjust deadzone if the default (20) doesn’t work
• Note: Recoil control also depends on your in-game sensitivity and weapon attachments.