Step 1: Initial Setup and Calibration

• Set your game sensitivity to 2/2
  • For Call of Duty: sensitivity 2 and multiplier 1.0 with standard curve and aim assist
• When launching the script:
  • Do not touch the joystick for 1 second (controller drift auto-calibration)

Step 2: Disable Mods Before Testing

• Ensure the following settings:
  • USE_AIM_ASSIST = FALSE
  • AR_TYPE = DISABLED
  • USE_STEADY_AIM = FALSE

How to Test:

• Set BOOST to 50
• Game sensitivity: 2/2 (or 10% in Fortnite)
• Move the right stick normally (hip & ADS sensitivity test)
• If movement feels:
  • Usual or slightly faster ➝ Test BALLISTIC_COEF range [10–100], start with 15 or 20
  • Too slow ➝ Increase game sensitivity and repeat the test
• Note:
  • Higher sensitivity = less tracking and stickiness
• Once sensitivity and coefficient feel good:
  • Adjust BOOST for fine-tuning starting at 30
  • Higher boost = more acceleration

Step 2 (continued): Anti-Recoil Setup

• Ensure the following:
  • AR_TYPE = USE_RUMBLE_EVIL_AR or USE_DYNAMIC_EVIL_AR
• Setup:
  • Enter a custom match or Plunder match
  • Adjust AR_STRENGTH range [-25 to 50]
  • Dynamic AR:
    • Weapon pulls down ➝ Decrease strength
    • Want more AR help ➝ Increase strength
  • Rumble AR:
    • Enable vibration in-game
    • Weapon pulls down ➝ Increase strength
    • Weapon goes up ➝ Decrease strength

Step 3: Aim Assist Configuration

• Ensure:
  • USE_AIM_ASSIST = TRUE
• Test AIM_MODULATION modes:
  • DISABLED — Balanced for all ranges
  • STEADY — Best for mid and long range
  • DYNAMIC — Best for close range
• For STEADY and DYNAMIC, test 3 scanning types:
  • FULL — Balanced headshot/tracking
  • VERTICAL — Headshot focused
  • HORIZONTAL — Tracking focused

Tuning Values:

• First tweak AIM_SLOPE range [4–20]
• Then adjust AIM_ASSIST range [12–32] (must be even)

Aim Assist Testing Method:

1. Enable Aim Assist = TRUE
2. Use AIM_MODULATION = DISABLED and SLOPE = 10
3. Test Aim Assist values: 16, 20, 24, 28, 32
   • If you get screen stutter or lose precision, reduce value
   • Fine-tune by ±2 from your best number
4. Keep best AIM_ASSIST value fixed and test SLOPE values:
   • 4, 8, 12, 16, 20
   • Again, fine-tune by ±2
   • This tuning is done with MODULATION = DISABLED

Advanced Modulation Testing:

• After tuning Aim Assist and Slope:
  • For STEADY or DYNAMIC, use best slope and subtract 2 from Aim Assist
    • Example: If best was 20, test 18 with modulation
  • STEADY: Good for long and close fights
  • DYNAMIC: Overpowered for close/mid range

Step 4: Steady Aim Configuration

• Ensure:
  • USE_STEADY_AIM = TRUE
• Adjust RESOLUTION: Test values 4, 6, 8